Product details
For use on hot or cold rolled steel and previously painted surfaces.
Benefits
Good adhesion to a variety of substrates. Mild odor. Very good hiding power and is good for interior or exterior use.
Specifications
| Application | |
|---|---|
| Method | May be brushed, rolled or sprayed. Use as is for brush and roll applications. Thin 5–15% for spray application depending on equipment. |
| Surface Preparation | Surface should be free of dirt, oil, grease and foreign contaminants. Rusty areas should be wire brushed or sandblasted and properly primed before top coating. |
| Recommended Primer | 12520, 763, 14022 |
| Thinning & Clean-Up | VM&P Naphtha for quicker flash off time or Mineral Spirits to hold a wet edge. Clean up with the same or a low cost gun cleaner. |
| Mixing | |
| Viscosity | 72–78 KU |
| Dry Time | |
| Dry Time @ 70ºF | 6–8 hours tack free, 24–36 hours to handle and recoat |
| Gloss @ 60º | 15–20% |
| Regulatory | |
| V.O.C. | 3.5 lbs/gal maximum, 3.2 lbs/gal typical |
| Solids By Volume | 53% averae |
| Hazard Data | Lead and Chromate Free. Flash point over 100ºF |
| Technical Data | |
| Weight | 9.4lbs/gal average |
| Theoretical Coverage (No Loss) | 760 square feet per gallon @ 1 mil dry (no loss) |
| Practical Spreading | 430 square feet per gallon ! 1.5 mils dry (assumes 15% loss) |
Related Products
