Product details
Klinger’s rust conversion coating is recommended for use on all ferrous metals as a rust converter. This product is designed to be used where proper cleaning, or sandblasting of the substrate is not possible, or difficult to achieve. Water-based, extremely low VOC’s, environmentally friendly. It does not contain tannic, or phosphoric acids. This product can be top coated with water-based, or solvent-based topcoats.
Comments
For outdoor applications this product should be top coated. Typical applications would be; general metal, marine, tanks and structural steel. For severely corroded steel a second coat of the rust conversion coating is recommended to avoid any pinholes, or breaks in the film.
Specifications
| Application | |
|---|---|
| Method | Brush, roller, or spray. Apply as supplied or thin sparingly. |
| Surface Preparation | Any loose rust or mill scale should be removed with a wire brush and the rusty steel should be power washed to remove any contaminants. |
| Thinning & Clean-Up | Use water to thin if needed (no more than 10%). Clean up with water. |
| Mixing | |
| Viscosity | 80–85 KU |
| Dry Time | |
| Dry Time @ 70ºF | 1 hour to handle. 12–24 hours to recoat. |
| Gloss @ 60º | Low |
| Regulatory | |
| V.O.C. | 0.19 lbs/gal, 22.8 g/l |
| Solids By Volume | 40.86% |
| Hazard Data | No Flash Point |
| Technical Data | |
| Weight | 12.04 lbs per gallon |
| Theoretical Coverage (No Loss) | 655 square feet per gallon at 3 to 5 mils dry |
| Practical Spreading | 130–220 square feet per gallon at 3 to 5 mils dry |
Related Products
